https://nordiclab.org/tags/minilab/Recent content in Minilab on NordicLabHugo -- 0.166.0en-usMon, 14 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/jobo-atl1500-lift-arm/Mon, 14 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/jobo-atl1500-lift-arm/Diagnosing a JOBO ATL-1500 lift arm that randomly rises during a process and stays up instead of cycling normally — sensor construction, ranked likely causes, the built-in service test, and a practical inspection order.https://nordiclab.org/repair-help/noritsu-v50-rack-gear-pitch/Mon, 14 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/noritsu-v50-rack-gear-pitch/How to realign the drive sprocket and feed idle gear timing marks after removing them from a Noritsu V50 processing rack shaft — the one correct gear position and why it matters.https://nordiclab.org/repair-help/noritsu-v50-cd-heater-diagnostics/Sun, 13 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/noritsu-v50-cd-heater-diagnostics/Full test procedure for a Noritsu V50 CD tank heater that heats to a point, plateaus below setpoint, then drops — fuses, connector chain, heater/thermosensor resistance tables, and how critical it is to run a wrong-model heater.https://nordiclab.org/repair-help/noritsu-v50-guide-film/Sun, 13 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/noritsu-v50-guide-film/Identifying and replacing the GUIDE, FILM part (A239395-01) in a Noritsu V50 Rack 1 — the small two-pronged plastic clip that keeps film pressed into the roller path at the handoff between roller pairs, and a common, easy-to-miss cause of repeat jams at the same spot.https://nordiclab.org/repair-help/noritsu-v50-rack1-leader-card/Fri, 11 Sep 2026 00:00:00 +0000https://nordiclab.org/repair-help/noritsu-v50-rack1-leader-card/Removing a leader card stuck in Rack 1 (CD) on a Noritsu V50 — draining the CD solution, pulling the rack, opening the side plate, and the full processing-tank cleaning procedure this rack goes through during scheduled maintenance.